![]() To do this, use the "Advanced settings" link in the Windows Firewall control panel and examine both "Incoming Rules" and "Outbound Rules". You may need to manually remove the original block rules from the firewall. Even if you later add a rule to allow the application, it may still be blocked. If you take any action other than clicking "Allow access", then the application may be forever blocked. At a minimum, you must click "Allow access" or "Unblock" for the software to function correctly. When running any SyncDat software for the first time, you may see a dialog box similar to the one below. However, it is still a good idea to manually review your firewall settings to ensure that the SyncDat port is open and that there are no block rules applying to it or the SyncDat applications. When "Run as Administrator", the server will attempt to correct problems it finds. When installing the SyncDat server, it will attempt to detect firewall problems and display warnings during installation. Extra steps may be required to ensure that ExpeDat data is allowed to pass through unhindered. The Windows firewall can be very aggressive about both blocking applications and degrading their performance. For example, " syncdat -l localpath Firewall With the syncdat client, use the -p option to specify the port, or the server name followed by a plus sign and the new port. If you change a server's port, then clients will need to specify the new port whenever they communicate with that server. See the Configuration File section for instructions on setting configuration variables. The servedat listen port is set using the Port configuration variable. Changing the server's port may be desirable if UDP/IP 8080 is already in use by another application, or if its use is restricted by firewall or administrative rules. The SyncDat server can be configured to listen for clients on any available UDP/IP port number. In most environments, it is not necessary to open ports on the client-side firewall. Should you experience difficulty with a network device, consult the Troubleshooting chapter, or refer to DEI Tech Note 0002 for information about configuring firewalls. ![]() If you are considering use of a network emulator, see Tech Note 0022 for important information about emulators. You can also configure SyncDat to use any other UDP/IP port number, if that is more convenient. If there are firewalls, VPNs, or NAT devices between the computers, then these devices must be configured to allow traffic on UDP/IP port 8080. Your local workstation must have the syncdat client. The remote system must be running the servedat server. That is, each computer must have a unique IP address and be reachable by the others. To use SyncDat for transferring files between computers, the computers must be connected by an Internet Protocol (IP) network path. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |